Adapt3D

After an influx of requests for DeWalt and AEG adaptors we have answered the calls and now have both in stock to add to the already popular Makita and Milwaukee adaptors 🤙.

(Note. The DeWalt adaptors are for their 18v XR it is not recommended you run the 54v flex volt. We will not be held accountable for any damages caused by over voltage if you try the 54v.)

The first orders of adapters are landing on customers doorsteps and the response has been amazing!

Here's Allan's Stacyc 16" freshly fitted with the Milwaukee adapter! The bonus is that the adapters are interchangeable between the 12" and 16" models so he will be able to swap between his two bikes when needed 👌

Check out the review and pictures he left on our page below:

"Contacted Adapt3D as I was looking for an alternative to allow me to run the Stacyc for longer periods of time. Running both a 12inch and a 16inch for my kids required many batteries!
The Gents at Adapt3D hooked me up with a Milwaukee adapter which fits perfectly and allows me even to run a 12amp battery! Will now not have to worry about running out of Stacyc batteries!" - Allan

More shots of the Makita adapter on the Stacyc 12! High quality 3D printing that is a perfect fit every time 👌

Hours of riding on one charge! No more tears at charge time or spending money on expensive batteries that you already own 🙌

Currently stocking Makita and Milwaukee adapters but can adapt all the major brands on a pre-order basis. DM us to upgrade your Stacyc Edrive today!

#12 #16