Teknik Enterprises

, we are showcasing the power of MAGNASLOT at Hurco Tech Center, Pune...We invite you to Tech Center, Pune...SEEING IS BELIEVING

...Magnetic Chuck on Drilling Machine..How efficiently Magnetic Chuck is being used..Seeing is Believing

Lets see How we help our users to develop accessories...of course MAGNASLOT also needs some accessories...very easy ..even can be made from scrap material...made our of only Low Carbon Steel i.e. M.S.!!!Seeing is Believing

....Very easy to design fixture for Awkward shaped components..depth of cut is 8mm..Faster Change over time.... ...

With its very easy to design fixture to accomodate ackword shaped components. No for of 8mm!!! .. ...

Small Component Machining :: Challenging and Time Consuming?

Not any more with our patented MAGNASLOT whether forged component or as cast ...MAGNASLOT is for all finishes...Seeing is Believing

Small components machining :: A Challange & Time consuming?..Not any more with our Patented MAGNASLOT ..let it be as forged or as cast ..No issue...MAGNASLOT is for all materials

Heavy Milling with Magnetic Chucks acknowledged by Indian Railway

in last 6 years, rejection has reduced to zero from 800 components per year !!!!!...possible due to MAGNASLOT only..

We have successfully installed MAGNASLOTS at machining shop of World leader in DG Sets to machine connecting rod. The facility is located in Western Maharashtra.
The general method to clamp the connecting rod is to hold the component by using internal expanding chuck in big end and small end. These internal expanding chucks do not allow the move the job horizontally but while machining there is always chances of the job getting lifted from the location. To arrest this vertical movement, one hydraulic clamp is also used at non machined area on the component. Due to this clamp there are chances of bending component, which leads to rejection of component which is a huge loss.
With MAGNASLOT, only horizontal movement of the job has to be arrested. The MAGNASLOT do not allow vertical movement. This resulted in increasing the cutting feeds from 560 mm/min to 750 mm/min (tried upto 1250mm/min).
This helped the customer to increase the productivity by 20% and most importantly reducing the rejection rate to 0%.

MAGNASLOT : Running on Horizontal Machining Center ( ). No clamps required. More than 50% Increase in .