Benson Built Srt
Here for all your Srt4 needs except dyno tuning. Engine rebuilds, transmission rebuilds we got ya!
Got the shop car looking right and ready for the track last weekend on some downtime. Now time to jam on another orange blast build that was dropped off!
Y’all come check me out. Put this one together last year for a customer from a bare shell, just made another 1/4 mile pass going 10.22 at 140mph with no issues. Maintenance or full builds, we got you covered.
What’s going on guys? Hope everyone had a great weekend. Haven’t posted in awhile due to being super slammed here at benson built, but would like to show one I finished up about a week ago.
This car was dropped off at a VERY well known srt4 shop in NC due to it having issues getting stuck in gear when hot. The car was tore apart immediately with a new act clutch kit thrown at it.
Upon pickup of this car, customer was having the same issues about 20 minutes up the street. So I had him tow the car to me.
After spending over 2000$ at another shop from misdiagnosis, and 100$s in tow bills the car arrived at my shop.
Upon arrival as soon as I fired the car up I could hear abnormal noise coming from the gearset, so I drained the fluid to find a lot of metal shavings and plastic pieces from a bad needle bearing.
The 5th gear needle bearing had gone bad and 5th gear had locked itself to the output shaft, car also had a 3rd gear grind.
Upon tear down, 5th gear output and input gears were bad, 3/4 synchronizer was worn out along with the 3/4 fork, and the 3rd gear engagement teeth were rounded off, output shaft bearing surface was gouged and scarred really bad.
Replaced all parts and car is back on the road. Listen guys, DONT HESITATE TO BRING YOUR CAR TO ME.
I can do anything from full transmission in house rebuilds, to fully built 800+hp engine builds.
HERE AT BENSON BUILT WE STRIVE TO KEEP OUR CUSTOMERS HAPPY AND MAKE SURE TO GUARANTEE A FIX FIRST TIME.
Had 3 come in this week with transmission issues, got one tore down on the table to find out the 3/4 snap ring broke causing 4th gear to walk on the shaft. This then causes the 4th gear roller bearing to wear out prematurely and catastrophic failure to the input shaft.
Finished up a full motor swap with new gaskets and a mopar stage 3 install for a customer a couple weeks ago. Few pictures from that build.
Had one dropped off a few weeks ago that was knocking, he brought me an engine last week and I threw it in. It runs great. Let me know if you guys need any work. Don’t hesitate to to message me, I guarantee all my work, and can take care of anything you need except dyno tuning. From 800hp builds to swapping stock motors, I do it all.
Y’all don’t hesitate to come see me. From 800hp full builds to fixing some hacked up wiring. You need it work done? I can do everything except dyno tune.
Just finished up 3 engine swaps and a head/cam install package. Hit us up for all your srt4 needs. From engine rebuilds, to transmission rebuilds, anything srt4 besides tuning I can get you taken care of!
Couple of my personal cars hanging out.
Click here to claim your Sponsored Listing.
Category
Telephone
Website
Address
Clemmons, NC
27012
Clemmons, 27012
Experienced Auto detailer based in Clemmons, North Carolina.