Fab_Plus

Riser extensions that was built for a customer. 4x4 .375 tube with 1/2 mounting plates. What project can we help you with? Start to finish or anywhere in between we welcome the opportunity to serve your needs.

Repair on a customers chipper truck, old hinges had been broke and welded several times and was hard to open/close and was having to be ratchet strapped shut . Tailgate was rebuilt with a new end section of 2”, new hinges were fabricated from 1 1/4 cold roll, and DOM Tubing, with added Grease fittings. Let us help make your work and life easier by getting your equipment repaired and functioning properly.

Some repairs are funner than others. Really enjoyed this Malibu trailer job. Rear Fender was damaged and had to be cut off and replaced, painted with oem urathane straight from the factory and installed new Seadek.

Internal Baffle repair on a 65 Gallon Hydraulic tank off of a Boom arm mower. Access port was cut, baffle welded then the port was welded back up with root pass, ground down flush then added cap weld.

Rear skirt for a Flatbed with recessed LED’s

Skid steer repair. All of the studs were sheared off and wheel stud holes oblonged out. Pressed in 8 new studs, welded up the wheel and redrilled then added 60 degree taper on bolt holes to accommodate lug nuts.

Overland Bed rack we built a few months ago From 2x1 .120 tube. Was designed to allow the backflip bed cover to operate normally.

Truck frame was rusted and completely cracked into, The bolted on plate was removed allowing the frame to be jacked back up level and straight and then welded and braced, backside of frame was also boxed in to add strength.

Small mobile repair on a trailer tongue at a Customers farm.

Replaced stainless fenders with drive over steel fenders. Framed with 3” C chanel and 3” .250 Angle Iron And covered with 11gauge steel tread plate.

Offering in house and mobile Metal Fabrication and Repair Welding. With Line Boring services available and mobile Line boring coming soon. Located in Sweetwater, TN and Servicing 1 hour radius (Knoxville to Chattanooga) in our standard area and a 3 hour radius (Nashville, TN to Asheville, NC) in our Extended Area.

Every business manager and owner understands that down time is a direct loss of income. Our mobile services can offer you and your business The support needed to minimize those downtime losses.

Metal frame for a raised Wood stove hearth to allow firewood storage underneath.

48’ lean-to storage shed with 24’ free span front openings

Dana 30 truss and skid plates

18x33 lean to with recessed purlin pockets

Building Handrail / Warehouse Traffic Guardrail

Custom Telehandler work platform, AKA Man Basket

Welding table

Boat Cradles

Branding Iron for a customer.