Anderson's Fabrication and Upfitting

This customer was complaining of a non working heater, I diagnosed the heater core to be clogged so I replaced it with a factory one and now the customer has a working heater again.

Knocked out some minor repairs on this Chevy 2500 front end, it needed a new cv axle and a upper ball joint for the aftermarket control arm. The pitman arm and idler arm with bracket were wiped out as well and needed replacing so they got upgraded to kryptonite Products.

This jeep showed up with a no start issue as well as it needed a new clutch. Got the starting issue figured out as well as replaced the clutch, throw-out bearing, and the clutch master cylinder. After disassembly I noticed the rear u-joint on the drive shaft was smaller than it was supposed to be and the transmission mount was broken. Got the correct u-joint as well as a new transmission mount installed.

Customer replaced all trailer lights and wiring with a new kit but still was having issues. Turns out he was having a bad grounding issue quick fix and it's back on the road.

Replaced this Ford factory air intake with a S&B cold air intake to help this truck breath a little better

Knocked out this 4" superlift kit on a dodge 3500 with fox 2.0 shocks and the fox 2.0 dual steering stabilizers. Upgraded the factory balljoints to kryptonite balljoints as well as some new 37" toyo r/t tires to finish it off.

Just finished up installing this led mood light / underglow kit with a upgraded bluetooth controller. Also added some upgraded brake pads and rotors.

Rebuilt the front end on this 2012 Dodge 3500 it was wiped out. New upper and lower ball joints, new hub bearings and speed sensors, new axle u-joints, and new inner and outer tie rod ends.

Installed a 4.5" rough country kit on this tundra for a little extra ground clearance. Now time for some beefier tires.

Welded up these stall gates for a customers new animal shelter

Hooked this customer up with some Plash lights rgb led strips in his grill and sub grill. Also installed a 12 piece white rock light set with more lighting to come.

Installed this new set of glow shift gauges with a quad pod for the A pillar. Egt's, boost, trans temp., and a fuel pressure gauge to keep this 7.3 running healthy.

Customer had 2 failing injectors on his 6.6 duramax so we went ahead and changed all the injectors, gaskets, fuel lines, and a injector cup. Also threw in a coolant flush, fuel filter, and oil change.

Got to install this new weather guard drag up tank and finished it off by wiring it up to the factory upfitter switches.

Installed a new Precision Armor heavy duty bumper on a 299D3xe. Has a 17.5k smittybilt winch mounted inside the bumper to get you out of those sticky situations.