RMKDrones, LLC
Microelectronics, microsoldering, data recovery, robotics, drones.
25/01/2023
19/03/2020
19/03/2020
28/02/2020
04/01/2020
Specializing in DJI (I also do other brands on a case-by-case basis due to limited parts availability).
Short turn-around time depending on severity of your damage(s).
$25 non-refundable deposit for diagnosis and estimate (this will go towards the total cost of repair).
Microelectronics SMD re-work done whenever possible to save on repair costs.
Re-flash Bootloader on non-functioning (bricked) mainboards as a result of failed firmware upgrades.
Replace broken USB-A ports on Mavic series RCs (parts are extremely difficult to obtain). My solution involves delicate component-level work to bring it back to specs.
All my meticulous repairs are done in-house in my well-equipped lab. I don't outsource my work nor take shortcuts with the workmanship.
ON-SITE emergency repairs by appointment.
I buy crashed, unwanted drones. Let me know what you have.
OTHERS: I also do different types of SMD microsoldering re-work on a case-by-case basis (ie. USB-C ports; manufacturer-specific interfaces; LSI chip replacements; LIDAR repairs, etc.). I also do data recovery of specialty electronics.
*****************************************************************************
About me: Electrical Engineer, Microelectronics Enthusiast; FAA Part 107 Pilot; Cisco Certified Network Engineer
*****************************************************************************
TAGS:
DJI UAV UAS drone crash calibration repair