Madden Car And Commercial Services

Madden Car And Commercial Services

Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Madden Car And Commercial Services, Automotive repair centre, .

04/03/2024

Volvo FM with loss of functionality error on the dash, read fault codes and error pointed to power loss to RCIOM, feeds checked and one was dead, found and repaired the broken wire 👌🏼

30/12/2023

I’m looking to take on a semi skilled mechanic to help repair and maintain primarily trailers and the odd truck/ bus. The ideal person would have some experience working on trailers repairing brakes and suspension components, MUST have their own tools (specialist tools will be provided), being able to MIG weld would be a huge advantage though training would be given to the right person. an actual interest in the job is a must. Would consider taking someone on with no HGV experience (car mechanic) providing they’re eager to learn. Driving license is essential. Wages will depend hugely on the applicants ability but the right person with the right work ethic will be well paid.

01/09/2023

DAF LF road sweeper with gearbox fault, stripped gearbox loom and found various wires rubbed through and broken. Wires soldered back together and sealed with adhesive coated heat shrink and she’s back in business 💪🏼

26/08/2023

Called out to a stranded sprinter with a failed alternator. Fix ‘em where they fall

17/08/2023

Transit Custom timing belt replacement today, the belts run in oil on these engines (wet belt) and if not changed at the proper interval the belt degrades leaving fragments of rubber in the sump that inevitably end up clogging the oil pick up. Sump was removed on this one to clean all the debris and clean out the oil pump pickup to avoid possible oil starvation.

29/06/2023

Mercedes Sprinter engine swap earlier this week

06/06/2023

Ford Transit broken rear spring replaced

04/06/2023

Called out to a non starting Mercedes 814 mini bus this morning, found corroded terminals and a broken wire on the starter motor. New heavy duty terminal crimped on and all connections cleaned up and she’s away 🚐💨

01/06/2023

Mercedes Atego with a bent connecting rod sorted, engine seems to have sucked water through the intake and hydraulic locked cylinder 1 bending the rod.

30/04/2023

Cracked alloy wheel repaired

21/04/2023

Clutch replaced this morning on an 18 ton Iveco

15/04/2023

Called to a Transit tipper that had lost its brakes, found a corroded and split brake pipe. Made and fit a new pipe on site from stock on the van 👌🏼

30/03/2023

Rough running VW crafter fault finding this morning

25/03/2023

Faulty load cell diagnosed and replaced this morning on a tipper trailer equipped with on board weigher

06/03/2023

Called to look at a Peugeot 308 with “Low oil pressure” warning on the dash. After some investigation found the timing belt was breaking up and had blocked the oil pick up in the sump. Clean pick up, replace timing belt kit and it’s good to go 👌🏼

17/02/2023

Spring eye bushes replaced on an Iveco Daily mini bus this morning

06/02/2023

Weak, mismatched batteries and a rotten old terminal replaced on a DAF CF85 this evening.

31/01/2023

Engine swap on a Peugeot 308

29/01/2023

DAF skip waggon for 6 weekly inspection and roller brake test

26/01/2023

Called out to recover a vehicle that had been involved in an accident this evening,
If you’ve been in a bad’en, ring Madden !

26/01/2023

FM12 hook loader for pre-MOT inspection and roller brake test today

21/01/2023

Front and rear brake disc’s and pads, and rear anti roll bar bushes on this Mercedes 813 bus this morning

18/01/2023

Engine replaced on this transit connect

18/01/2023

Blowout damage repaired out of hours keeping the wheels turning 🚛💨

10/01/2023

ABS fault on a Montracon trailer equipped with Haldex Gen3 modulator, diagnostics showed fault with suspension pressure sensor which is part of the modulator valve and cannot be replaced without fitting a complete valve at £1300, fortunately it’s possible to fit an external pressure sensor if you have the right software to change the valve parameters so that’s what was done here saving the customer £1200 on a new modulator.

10/01/2023

Trailer axle bushes being replaced this morning. I think the old ones were past their best 😬

09/01/2023

Starter motor replacement on a Renault T Range

07/01/2023

Inspection and rear brake pad replacement on this Volvo FM tractor unit

22/12/2022

Rear discs and pads on this DAF road sweeper 👌🏼

Website