DME WORKS LTD

Had a super tidy vl commodore come in running an rb30e soon to be turbo, sorted out a full exhaust for the mean time remade the 2-1 collector on the factory extractors to 3” and also made a muffler delete so when he wants to blow eardrums he can!

Just finished up full Manuel conversion on super tidy low kms Type X 180sx! Loved working on such a clean and factory gem like this one!

Finished up rear winch bar rear quarter guard and swing arm to suit a 37” tyre, wanted to wait a week to post up some photos as the customer was taking it out to test it the week after! A lot went into this bar to make sure the customer was happy aswell as it was fully bolt on bolt off for legal reasons. Super stoked on how it turned out!

Just finished up a quick Friday job, bolt on 2.5 inch shotguns for this super tidy example of a jzx! Only 124 # # # on the dash what a jem!

Next up is a whole bunch of panel work for r32 front and rear widebody big boy skirts and gtr front on the horizon keep an eye out for the before and after shots 👀

Just finished up doing some work on very tidy c35 laurel club s, wof ready and sitting pretty. His widebody r32 will be getting some special bits put on it in the coming weeks keep an eye out 👀

Have also been chipping away at personnel cars as much as I can Silvia is back up and running moving on its own power for once and just awaiting a couple more parts before we can book in for tune but I’d say in the next week or two there should be some colour on it 🤷🏽‍♂️ Trucks also had a tray revamp again, bullbars front and rear made up, just about to start with new turbo and top mount intercooler setup then she’ll be getting put back together

Gave her a quick spray of primer so I can get out and do some RnD on the new tray setup, couple additions still to be made but will be ready to spray soon enough

Just finished up doing a roll bar for

if you’re in the market for any fabrication work, mechanical, and composite work flick us a message and we’ll sort you out!

Well a good friend of ours brought the 33 off us and it will be rolling into the shed in the next couple weeks for a full build, start off with some front end tube work drop the motor in full custom dash half cage with door bars, custom rear end with a little something special meaning that rear windscreens gotta go! Topped off with a bunch of one off carbon goodies and she’ll be sitting pretty soon enough

Just finished up making some custom base plates and backing plates for Arri’s Carbon Fibre 3DGT wing. Super tidy car can’t wait to see the next version of it!

Just finished up Josh’s cefiro little tidy up in the engine bay replaced a couple bits in the driveline to get ready for a wof and did a quick diff back exhaust 3”