FSJB Refregeration and Airconditioning Services

Chemical wash

Aircon Services Metro Manila and Regional
WE OFFER SERVICES:
Aircon Cleaning
Aircon Check up
Aircon Repair
Parts Replacement
Compressor Replacement
Recharging Freon Gas
Aircon Installation
Aircon Dismantling
Aircon Relocation
Ducting Works

Dual capacitor check out procedure

Test capacitor trouble shot

If there is not, then, check to see if the fan on the outside unit is running. If the fan on the outside unit is not running either, check to make sure that the breakers for the furnace/air handler and the air conditioner are on.

If the breaker is not tripped, then the problem may be your thermostat, the furnace/air handler control board, or the wires between the furnace/air handler and the thermostat.

If your unit has a condensate pump, check to make sure the reservoir is not full. If the reservoir is full, a limit switch will normally stop the air conditioner from running. You will need to repair or replace the pump.

If the breaker is tripped, you can reset it by shutting it off and then turning it back on. If it trips again, then check the wiring in the furnace/air handler for signs of damage and repair as necessary.

If the blower is running but the fan on the outside unit is not, then continue your air conditioner troubleshooting at the outside unit.

Is the fan on the outside unit blowing out hot air?
If the blower isn't running but the fan outside is, the problem could be the blower motor, it's run capacitor, or the furnace/air handler control board.

If the fan motor is not running, then shut the power off to the unit. Then check all wire connections for signs of damage such as burning and repair as necessary. You should also check the wire connections in the compressor terminal box and repair if necessary.

Air Conditioner Troubleshooting, Before You Call The Repairman ...
Before you make that call, try this basic air conditioner troubleshooting guide. This guide will help you to diagnose problems with your typical ducted split type air conditioner. A typical repairman will cost you about one hundred dollars per hour. With a few household tools and a little bit of knowledge, you can do it yourself and save that money. (You provide the tools and we will help with the knowledge part.)

You should ensure that the routine maintenance has been performed on the unit. If the air filter has not been changed in the past month, check to see if it is dirty.

**NOTE** ONLY YOU CAN ASSESS YOUR ABILITY TO PERFORM THIS TASK.

THIS IS A GUIDE AND CANNOT PROVIDE ALL OF THE DETAILS FOR EVERY SITUATION.

Begin your air conditioner troubleshooting at the thermostat by ensuring that the thermostat is on cool and that it is set lower than actual room temperature. This is to ensure that there really is a problem. It may seem silly but that is the first thing a repairman will check and you will normally still be charged a service call even if that is the only problem.