CRC Fabrication

Upper and lower Merillat torque box job finished up on a foxbody.

A little project that’s been on the back burner is finally finished up. This LTD got a tube front end, custom 10 point rollcage with through the floor subframe connectors with outriggers. Kirkey seats mounted on custom fabricated seat mounts. All painted up and ready to head home.

Another 8.50 cert cage wrapped up with through the floor subframe connectors, outriggers and some fresh glass.

Mikes car all buttoned up and heading out. That Big Block Chevy does look good in there.

Mike Barry’s hotrod is almost done. The underside and drivers compartment of the chassis is all welded up and painted. Some finish welding on the front end, paint and reassembly and then that big old boat anchor will be set back in. Tons of work done to the car. It’s the little things that you don’t see are what takes up a lot of the time. A lot of time and thought goes into these hotrods.

Mike’s car getting closer. Mock up engine block is in its final resting place, radiator’s mounted, custom weight bar welded up and mounted, misc bars and tabs welded up and drivers seat is secure. Just about ready to mount fenders and some paint.

Getting this boat anchor situated in Mike’s hotrod. Front ends coming together.

Rollin on Mike’s front end. A few more bars, gussets, mounts and tabs and it’ll be ready to rock n roll.

The start of a 25.3 cert update on a 25.5 cert car. Out with the old and in with the new.

Back in the shop making some progress on the LTD.

Another custom aluminum exhaust wrapped up.

A little seat time today.

This old LTD’s gutted and ready to cut into.

Kyler’s car back on the ground ready to head home.

Kyler’s cars front end completely disassembled, finished welding, painted and reassembled.

Back on Kyler’s hotrod. Rad and intercooler mounted. Down pipe done and intercooler piping fab’d up.

Quick cat back exhaust job on a Jeep Cherokee this morning.

Riley’s hotrod on the ground for the first time.

Riley’s floor just about buttoned up.

More floor work on Riley’s car.

Riley’s car getting a new floor.

Quick subframe connectors and 8.8 build with new control arm brackets a spool and 35 spline Strange axles.

Few little things I did to Teds car last week. Had to build a new trans crossmember for the TH400 trans, redo the motor plate to mate up to the belt drive and mount a radiator, add another bar and paint the tube front end.

Carter’s 03 Cobra in for some new torque boxes and an new rear gear set.

Riley’s car got its parachute mounted to its custom fabricated parachute mount and chute lever.

Riley’s car getting its wing.

Something a little different in the shop today for chassis and engine work. 1984 Ford LTD. Soon to be a single turbo sbe sbf.

Kyler’s car got it’s new front fascia today. Fits nice but will need some trimming and mounting.

Few more gussets and it’s ready to weld up.