VW T3 3d printing parts Videos

Parts for engine vent vw T3

Square lamp adjusters 4 types for one lamp you need: first type x 1 second type x 2 third type x 3 fourth type x 6 Set (without screws) for: 1 lamp - 25 eur 2 lamps - 50 Eur Shipping in europe - about 15 eur paypal

Still dancing;) but it is good news because my idle didn't do it;) time to look inside;)

This my idea of brown lever. How do you like it? :)

I didnt know that the weight of needle is important;) I need to think. Check the results;) do you know where I can buy needles

Almost finished:) about 100 eur total:)

2 stage done;)

Normal and plazma light.

One more thing to change. But for now they look good. Dash adjustable vents. OEM 255819955A

Adjustable roof vents. I've just finished project. Tomorrow printing but now the Dragon:) VW T3 3d printing parts

Because of your speedometer condition( cable, wheel nut, loose on speedometer plug, shacking needle, etc) impulses from speed sensor are not very stable and cruise control working badly. I have good speedo but I am thinking of you guys and you can use this info in your van. I connected camshaft position sensor which is also hall sensor to pin nr 20 in my ecu edc 15 which is responsible for reading the speed and on the film you can see the results. Now I can use my cruise control from 20 km/h. Of course you can change numbers of impulses in eeprom.

Android auto for vw t3. #camera #vwt3 #3dprinting

Not bad. Asz engine fhn gearbox about 170 hp

It was hard to vent fuel system but the engine runs. I am very happy:). Now I need to finish some small work and I am going to back on road soon.

Checking speed sensor for cruise control:)